| /drivers/rtc/ |
| A D | rtc_pcf8563.c | 68 const struct gpio_dt_spec int1; member
412 if (config->int1.port == NULL) { in pcf8563_alarm_set_callback()
426 ret = gpio_pin_configure_dt(&config->int1, GPIO_INPUT); in pcf8563_alarm_set_callback()
429 ret, config->int1.port->name, config->int1.pin); in pcf8563_alarm_set_callback()
433 ret = gpio_pin_interrupt_configure_dt(&config->int1, GPIO_INT_EDGE_FALLING); in pcf8563_alarm_set_callback()
436 ret, config->int1.port->name, config->int1.pin); in pcf8563_alarm_set_callback()
441 gpio_init_callback(&data->int1_callback, gpio_callback_function, BIT(config->int1.pin)); in pcf8563_alarm_set_callback()
442 gpio_add_callback(config->int1.port, &data->int1_callback); in pcf8563_alarm_set_callback()
495 (.int1 = GPIO_DT_SPEC_INST_GET_OR(inst, int1_gpios, {0}))) \
|
| A D | rtc_pcf2123.c | 128 struct gpio_dt_spec int1; member
547 if (config->int1.port == NULL) { in pcf2123_alarm_set_callback()
561 ret = gpio_pin_configure_dt(&config->int1, GPIO_INPUT | GPIO_PULL_UP); in pcf2123_alarm_set_callback()
567 ret = gpio_pin_interrupt_configure_dt(&config->int1, GPIO_INT_EDGE_FALLING); in pcf2123_alarm_set_callback()
573 gpio_init_callback(&data->int1_callback, gpio_int1_callback, BIT(config->int1.pin)); in pcf2123_alarm_set_callback()
574 ret = gpio_add_callback(config->int1.port, &data->int1_callback); in pcf2123_alarm_set_callback()
660 (.int1 = GPIO_DT_SPEC_INST_GET_OR(inst, int1_gpios, {0})) \
|
| A D | rtc_pcf8523.c | 123 struct gpio_dt_spec int1; member
247 err = gpio_pin_interrupt_configure_dt(&config->int1, in pcf8523_int1_enable_unlocked()
600 if (config->int1.port == NULL) { in pcf8523_alarm_set_callback()
661 if (config->int1.port == NULL) { in pcf8523_update_set_callback()
780 if (config->int1.port != NULL) { in pcf8523_init()
783 if (!gpio_is_ready_dt(&config->int1)) { in pcf8523_init()
788 err = gpio_pin_configure_dt(&config->int1, GPIO_INPUT); in pcf8523_init()
795 BIT(config->int1.pin)); in pcf8523_init()
797 err = gpio_add_callback_dt(&config->int1, &data->int1_callback); in pcf8523_init()
961 (.int1 = GPIO_DT_SPEC_INST_GET_OR(inst, int1_gpios, {0})))}; \
|
| /drivers/sensor/st/lsm6dsv16x/ |
| A D | Kconfig | 48 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ST_LSM6DSV16X),int1-gpios) ||\
51 $(dt_compat_any_has_prop,$(DT_COMPAT_ST_LSM6DSV32X),int1-gpios) ||\
59 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ST_LSM6DSV16X),int1-gpios) ||\
62 $(dt_compat_any_has_prop,$(DT_COMPAT_ST_LSM6DSV32X),int1-gpios) ||\
|
| /drivers/can/ |
| A D | can_mcux_mcan.c | 238 IRQ_CONNECT(DT_INST_IRQ_BY_NAME(n, int1, irq), \
239 DT_INST_IRQ_BY_NAME(n, int1, priority), \
242 irq_enable(DT_INST_IRQ_BY_NAME(n, int1, irq)); \
|
| A D | can_sam.c | 167 IRQ_CONNECT(DT_INST_IRQ_BY_NAME(inst, int1, irq), \
168 DT_INST_IRQ_BY_NAME(inst, int1, priority), can_mcan_line_1_isr, \
170 irq_enable(DT_INST_IRQ_BY_NAME(inst, int1, irq)); \
|
| A D | can_stm32h7_fdcan.c | 303 IRQ_CONNECT(DT_INST_IRQ_BY_NAME(n, int1, irq), \
304 DT_INST_IRQ_BY_NAME(n, int1, priority), \
306 irq_enable(DT_INST_IRQ_BY_NAME(n, int1, irq)); \
|
| A D | can_numaker.c | 282 IRQ_CONNECT(DT_INST_IRQ_BY_NAME(inst, int1, irq), \
283 DT_INST_IRQ_BY_NAME(inst, int1, priority), \
287 irq_enable(DT_INST_IRQ_BY_NAME(inst, int1, irq)); \
|
| A D | can_stm32_fdcan.c | 583 IRQ_CONNECT(DT_INST_IRQ_BY_NAME(inst, int1, irq), \
584 DT_INST_IRQ_BY_NAME(inst, int1, priority), \
586 irq_enable(DT_INST_IRQ_BY_NAME(inst, int1, irq)); \
|
| /drivers/sensor/bosch/bma280/ |
| A D | Kconfig | 29 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_BOSCH_BMA280),int1-gpios)
35 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_BOSCH_BMA280),int1-gpios)
|
| /drivers/sensor/bosch/bmi270/ |
| A D | bmi270_trigger.c | 187 ret = bmi270_init_int_pin(&cfg->int1, &data->int1_cb, in bmi270_init_interrupts()
201 if (cfg->int1.port) { in bmi270_init_interrupts()
292 if (!cfg->int1.port) { in bmi270_trigger_set()
|
| A D | bmi270.h | 336 struct gpio_dt_spec int1; member
|
| A D | bmi270.c | 802 .int1 = GPIO_DT_SPEC_INST_GET_BY_IDX_OR(inst, irq_gpios, 0, {}),\
|
| /drivers/sensor/adi/adxl345/ |
| A D | adxl345.c | 391 uint8_t int1) in adxl345_interrupt_config() argument
396 ret = adxl345_reg_write_byte(dev, ADXL345_INT_MAP, cfg->route_to_int2 ? int1 : ~int1); in adxl345_interrupt_config()
401 ret = adxl345_reg_write_byte(dev, ADXL345_INT_ENABLE, int1); in adxl345_interrupt_config()
|
| /drivers/sensor/adi/adxl362/ |
| A D | Kconfig | 74 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ADI_ADXL362),int1-gpios)
80 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ADI_ADXL362),int1-gpios)
|
| A D | adxl362.c | 99 uint8_t int1, in adxl362_interrupt_config() argument
105 ADXL362_REG_INTMAP1, &int1, 1); in adxl362_interrupt_config()
|
| /drivers/sensor/nxp/fxls8974/ |
| A D | Kconfig | 27 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_NXP_FXLS8974),int1-gpios) || \
|
| /drivers/sensor/bosch/bma4xx/ |
| A D | Kconfig | 41 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_BOSCH_BMA4XX),int1-gpios)
|
| /drivers/sensor/adi/adxl367/ |
| A D | Kconfig | 109 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ADI_ADXL367),int1-gpios)
115 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ADI_ADXL367),int1-gpios)
|
| /drivers/sensor/adi/adxl372/ |
| A D | Kconfig | 99 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ADI_ADXL372),int1-gpios)
105 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_ADI_ADXL372),int1-gpios)
|
| A D | adxl372.c | 365 uint8_t int1, in adxl372_interrupt_config() argument
371 ret = data->hw_tf->write_reg(dev, ADXL372_INT1_MAP, int1); in adxl372_interrupt_config()
|
| /drivers/sensor/nxp/fxas21002/ |
| A D | Kconfig | 62 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_NXP_FXAS21002),int1-gpios) ||\
|
| /drivers/sensor/nxp/fxos8700/ |
| A D | Kconfig | 53 depends on $(dt_compat_any_has_prop,$(DT_COMPAT_NXP_FXOS8700),int1-gpios) ||\
|